How to Care for Your Hardwood Outdoor Furniture
Share
Hardwoods like Merbau, Ironbark and Spotted Gum are built to last outdoors for decades, but a little regular care goes a long way toward keeping them looking their best, not just structurally sound. Here's what actually matters.
Expect the colour to change: that's normal
Freshly oiled hardwood starts out rich and warm-toned. Left outdoors, UV exposure will silver or grey the surface over months, especially on unfinished or lightly oiled pieces. This is a natural weathering process, not a fault, and it doesn't affect the timber's strength or durability. If you want to keep the deeper colour, re-oiling is the fix (see below); if you're happy with a natural silver-grey patina, you can simply let it weather.
Oiling: the single most useful thing you can do
For oiled or raw hardwood finishes, an oil re-coat once or twice a year (more in harsh coastal or high-UV areas) keeps the timber's colour and adds a layer of surface protection. The process is simple:
- Clean the surface first (see below) and let it dry fully.
- Lightly sand any rough or splintered areas with fine sandpaper.
- Apply a timber oil suited to outdoor hardwood, following the product's directions, usually a thin, even coat with a cloth or brush.
- Let it cure fully before use, typically 24–48 hours depending on weather.
Cleaning
A soft brush or cloth with warm water and mild soap is enough for regular cleaning. Avoid high-pressure washers directly on the timber, as they can strip the surface and force water into the grain. For built-up grime or mould in shaded, damp spots, a diluted oxygen-based cleaner (not bleach) followed by a rinse works well.
Watch the legs and joints
Hardware and joints are usually the first place wear shows. Check bolts and fittings are still tight each season, and keep an eye on any galvanised hardware for surface rust; a light wipe-down prevents staining onto the timber around it.
Covered vs uncovered use
If your table sits under a pergola or veranda, a full varnish finish will hold its look for longer with less maintenance, since it's not taking the full brunt of sun and rain. Fully exposed pieces do better with an oiled finish, since oil can be reapplied in patches without stripping the whole surface first.
A simple seasonal routine
- Each season: wipe down, check hardware
- 1–2 times a year: clean thoroughly and re-oil (oiled finishes) or spot-check varnish for wear
- As needed: light sand and re-coat any high-wear areas (tabletop edges, bench seats)
Looked after this way, a Class 1 hardwood piece from our range is built to perform well beyond its 12-month warranty, often for decades.
Questions about caring for your specific piece? Get in touch and we're happy to help.